Table of Contents
Advertisement
NetCol8000-C(070-260) In-room Chilled Water Smart
Cooling Product
User Manual
Figure 3-36 Removing a hold hoop
Step 4 Remove the hold hoop securing the bend using a 15# socket wrench. To avoid deforming the
pipe, use a 75# open-end wrench to fix the pipe nut, use a 36# open-end wrench to fix the
plug at the lower part of the bend, and then remove the plug.
Figure 3-37 Removing a pipe hold hoop and plug
Step 5 Connect the threaded connecting ends removed from the straight pipe to the external pipe
(apply thread sealant on the joints of external screw threads), and secure them using a 75#
open-end wrench and an 18# pipe wrench, as shown by (1) in
Step 6 Connect the other end of the straight pipe to the pipe of the smart cooling product using a
black sealing ring (seal the pipe connection point using a black sealing ring), as shown by (2)
in
Figure
Issue 06 (2020-01-13)
3-38.
Copyright © Huawei Technologies Co., Ltd.
3 Installation Guide
Figure
3-38.
67
Advertisement
Table of Contents
