Table of Contents
Advertisement
NetCol8000-C(070-260) In-room Chilled Water Smart
Cooling Product
User Manual
the cold air can cool the device directly. It is recommended that the angle downward should
not exceed 30 degrees to avoid that part of the cold air flows back to the smart cooling
product, affecting the cooling effects.
Procedure
Step 1 Remove the cap front panel using a Phillips screwdriver. Place the cap on the top of the
cabinet.
It takes two persons to install the cap using a 2 m step ladder.
Figure 3-86 Removing the cap front panel
Step 2 Secure the left and right sides of the cap using six M5 screws and the front and rear of the cap
using four M5 screws.
Issue 06 (2020-01-13)
Copyright © Huawei Technologies Co., Ltd.
3 Installation Guide
115
Advertisement
Table of Contents
