Huawei NetCol8000-C User Manual page 147

NetCol8000-C(070-260) In-room Chilled Water Smart
Cooling Product
User Manual

Procedure
Step 1 On the home screen, choose Settings > Comm Settings > IP Settings.
Step 2 Set the parameters by referring to
Table 4-9 IP parameter settings
Parameter
IP assigning
mode
IP address
Subnet mask
Gateway
Step 3 Tap Submit.
Step 4 On the home screen, choose Settings > Comm Settings > Modbus Settings.
Step 5 Set parameters for Modbus TCP by following instructions.
Table 4-10 Modbus TCP parameter settings
Parameter
Link mode
Client
encryption
Server
encryption
NMS IP
Issue 06 (2020-01-13)
If Link mode is Server, a smart cooling product can be accessed by element
management system (EMS) client. If Link mode is Client, a smart cooling product can
be connected only to the EMS with the corresponding IP address. If Link mode is
Server and client, a smart cooling product can be accessed by EMS client and connect
to the EMS with the corresponding IP address at the same time.
Setting Method
Set according to the actual plan.
Set according to the actual plan.
Set according to the actual plan.
Set according to the actual plan.
Setting
Server, Client,
Server and
client
Enable,
Disable
Enable,
Disable
N/A
Copyright © Huawei Technologies Co., Ltd.
Table 4-9.
Setting Method
 If you set Link mode to Server, the smart cooling
product, as a server, supports two client connection
and establishes communication.
 If you set Link mode to Client, the smart cooling
product, as a client, can connect to a remote server and
establish communication.
 If you set Link mode to Server and client, the smart
cooling product, as a server, supports two client
connection and establishes communication. In
addition, the smart cooling product, as a client, can
connect to a remote server and establish
communication.
This parameter is configurable when Link mode is set to
Client.
This parameter is configurable when Link mode is set to
Server.
Enter the actual IP address of the EMS. IP addresses of
4 Commissioning
139