Timer/Counter Timing Diagrams - Atmel AT90PWM2 Manual

8-bit avr microcontroller with 8k bytes in-system programmable flash
Table of Contents

Advertisement

14.7

Timer/Counter Timing Diagrams

4317I–AVR–01/08
match between OCR0x and TCNT0 when the counter decrements. The PWM frequency for the
output when using phase correct PWM can be calculated by the following equation:
The N variable represents the prescale factor (1, 8, 64, 256, or 1024).
The extreme values for the OCR0A Register represent special cases when generating a PWM
waveform output in the phase correct PWM mode. If the OCR0A is set equal to BOTTOM, the
output will be continuously low and if set equal to MAX the output will be continuously high for
non-inverted PWM mode. For inverted PWM the output will have the opposite logic values.
At the very start of period 2 in
there is no Compare Match. The point of this transition is to guarantee symmetry around BOT-
TOM. There are two cases that give a transition without Compare Match.
OCRnx changes its value from MAX, like in
OCn pin value is the same as the result of a down-counting Compare Match. To ensure
symmetry around BOTTOM the OCnx value at MAX must correspond to the result of an up-
counting Compare Match.
The timer starts counting from a value higher than the one in OCRnx, and for that reason
misses the Compare Match and hence the OCnx change that would have happened on the
way up.
The Timer/Counter is a synchronous design and the timer clock (clk
clock enable signal in the following figures. The figures include information on when interrupt
flags are set.
Figure 14-8
shows the count sequence close to the MAX value in all modes other than phase correct PWM
mode.
Figure 14-8. Timer/Counter Timing Diagram, no Prescaling
clk
I/O
clk
Tn
(clk
/1)
I/O
TCNTn
TOVn
Figure 14-9
shows the same timing data, but with the prescaler enabled.
f
OCnxPCPWM
Figure 14-7
OCnx has a transition from high to low even though
Figure
contains timing data for basic Timer/Counter operation. The figure
MAX - 1
MAX
AT90PWM2/3/2B/3B
f
clk_I/O
=
----------------- -
N 510
14-7. When the OCR0A value is MAX the
) is therefore shown as a
T0
BOTTOM
BOTTOM + 1
95

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AT90PWM2 and is the answer not in the manual?

Questions and answers

This manual is also suitable for:

At90pwm3At90pwm2bAt90pwm3b

Table of Contents