Print Head Fault Code Problem Solving - Xerox CiPress 325 Customer Help Information

Problem Solving
XPE-15-XXXX Faults
XPE-15-29XX
Cause: Normalize Heads Phase Failed to Converge
Remedy: Reset the fault and attempt to run the Normalize Heads Phase
again. If the fault continues to occur, contact Xerox for assistance.
XPE-15-43XX
Cause: Converge Roll Phase Failed to Converge for X-Registration
Remedy: Reset the fault and attempt to run the Converge Roll Phase
again. If the fault continues to occur, contact Xerox for assistance.
XPE-15-44XX
Cause: Converge Roll Phase Failed to Converge for Roll
Remedy: Reset the fault and attempt to run the Converge Roll Phase
again. If the fault continues to occur, contact Xerox for assistance.
XPE-15-45XX
Cause: Register Heads Phase Failed to Converge for X Coarse
Remedy: Reset the fault and attempt to run the Register Heads Phase
again. If the fault continues to occur, contact Xerox for assistance.
XPE-15-46XX
Cause: Register Heads Phase Failed to Converge for Y Coarse
Remedy: Reset the fault and attempt to run the Register Heads Phase
again. If the fault continues to occur, contact Xerox for assistance.
XPE-15-47XX
Cause: Register Heads Phase Failed to Converge for X Fine
Remedy: Reset the fault and attempt to run the Register Heads Phase
again. If the fault continues to occur, contact Xerox for assistance.
XPE-15-51XX
Cause: Correct Ydp Phase Failed to Converge
Remedy: Reset the fault and attempt to run the Correct Ydp Phase again.
If the fault continues to occur, contact Xerox for assistance.

Print Head Fault Code Problem Solving

Fault codes that refer to a Print Box Unit (PBU) are given the following assignment:
5-52 ®
Xerox CiPress 325 / 500 Production Inkjet System
Customer Help Information
These faults
are related
to DC 141
Head Setup.