Problem Solving
The Web Registration Module responds too slowly and is not guiding the web
appropriately.
The gain is set too low.
Remedy:
1.
Optimize Gain for Primary (Upstream)
2.
Optimize Gain for Secondary (Downstream)
Activate material setup on Primary (Upstream)
3.
4.
Perform Material Setup for Primary (Upstream)
5.
Activate material setup on Secondary (Downstream) CiPress.
Perform Material Setup for Secondary (Downstream)
6.
The Web Registration Module is not guiding the web.
The gain is set too low.
Remedy:
Optimize Gain for Primary (Upstream)
1.
2.
Optimize Gain for Secondary (Downstream)
When set to Automated Mode, the Web Registration Module moves to an end position
and stays there (when the web is being threaded).
• Material setup was not run after the web was changed.
• The guiding direction has not been set up properly.
Remedy:
1.
Activate material setup on Primary (Upstream)
Perform Material Setup for Primary (Upstream)
2.
3.
Activate material setup on Secondary (Downstream) CiPress.
4.
Perform Material Setup for Secondary (Downstream)
5-10
CiPress.
CiPress.
CiPress.
CiPress.
CiPress.
CiPress.
CiPress.
CiPress.
CiPress.
CiPress.
®
Xerox
CiPress 325 / 500 Production Inkjet System
Customer Help Information