Xerox CiPress 325 Customer Help Information page 180

Maintenance Tasks
18. Grabbing the Print Head on its sides, align the new Print Head (with the safety cover
on) to the ball plate and fully insert the Print Head. Make sure that the pin connector
and the two ribbon cables are out of the way as you insert the new Print Head onto
the ball plate.
19. Fasten Print Head screws: Start with the left screw alternating two turns each for the
left and right screw until both screws are tightened completely. The right screw should
be finished last. Finish seating the left screw first and retighten the right screw. Feel
for the Torque Driver clutch override.
20. Attach the pin connector and then the two ribbon cables and remove the cover from
the Print Head.
21. Make sure the ribbon cables are securely connected and properly aligned. Visually
check that all connectors are completely seated. If the print head is not properly
7-8 ®
Xerox CiPress 325 / 500 Production Inkjet System
Customer Help Information