Xerox CiPress 325 Customer Help Information page 160

Problem Solving
14. Check the Print Head connectors to ensure they are fully seated.
Note
See steps 20 and 21 of the respective Print Head replacement procedure for more
information on the connectors.
• How to Replace Print Heads from Left Marking
• How to Replace Print Heads from Right Marking
Result
The connectors are not fully
seated.
The connectors are fully
seated.
Note
Before performing the next step, record which Print Head has the fault so that you
can more easily locate it at a later time.
5-58
Tower.
Tower.
Action
1.
Ensure that the connectors are fully seated.
2.
Follow steps 22-27 of the respective Print Head
replacement procedure.
Note
Do not run DC 965 or DC 141 after closing the
respective Marking Tower Front Door.
3.
Use the Check Pages feature to print 100 frames of a
job.
Note
For more information on enabling this feature, see
Setting the Number of Pages for a Check Page Routine
and Printing a Check Pages
4.
If the same fault occurs again, and continue with
the next step.
If the same fault does not occur again, the procedure
is complete. Run DC 965 and DC 141 prior to printing
any jobs.
Continue with the next step.
®
Xerox CiPress 325 / 500 Production Inkjet System
Routine.
Customer Help Information