Commissioning The Access Control System; Commissioning A Door Status Sensor (Connected To The Ai/Di Port On The Rack Environment Unit); Commissioning An Access Control Device And A Cabinet Electronic Lock - Huawei FusionModule5000 Commissioning Manual

FusionModule5000 Smart Modular Data Center
Commissioning Guide

6.6.3 Commissioning the Access Control System

6.6.3.1 Commissioning a Door Status Sensor (Connected to the AI/DI Port
on the Rack Environment Unit)
If a door status sensor is installed, perform the following steps to configure it.
Context


Procedure
Step 1 Choose Monitoring > Cabinet > IT Cabinet1 > Cabinet Collector1 > Running
Parameters, set the door status sensor parameters.
Table 6-11 Parameter settings
Setting
area
AI/DI_1
Port
Settings
AI/DI_2
Port
Settings
Step 2 Check the door status sensor functions.
Table 6-12 Commissioning the sensor
Check Method
Close and then open the door.
----End
6.6.3.2 Commissioning an Access Control Device and a Cabinet Electronic
Lock
If an access control device and cabinet electric lock are installed, perform the following steps
to configure it.
Issue 06 (2020-03-20)
If the sensor is prefabricated, only check its settings.
If multiple door status sensors are connected, commission one door status sensor first
and then commission the other door status sensors in the same way.
Object
Front door
status
(AI/DI_1)
Rear door
status
(AI/DI_2)
Copyright © Huawei Technologies Co., Ltd.
Method
1. Choose AI/DI_1 sensor to Enable, click Submit.
2. Set AI/DI_1 sensor type to Door sensor, click Submit.
1. Choose AI/DI_2 sensor to Enable, click Submit.
2. Set AI/DI_2 sensor type to Door sensor, click Submit.
Normal Connection Status
If the alarm is enabled for the front and rear doors, a
cabinet door open alarm is displayed on the active
alarm screen of the app or the active alarm page of the
WebUI.
6 Commissioning the Management System
72