How Is A Signal Name Changed; How Should I Link The Smoke Alarm With The Alarm Beacon Over The Ecc800 Webui - Huawei FusionModule5000 Commissioning Manual

FusionModule5000 Smart Modular Data Center
Commissioning Guide
Step 7 Click Select in the Output Dry Contact column corresponding to Operation log full as
required, select Yes or No for DO1 or DO2, and click OK.
Select a DO not used by other functions. Otherwise, the association setting fails.
Step 8 Click Select in the Loudspeaker column corresponding to Operation log full as required, set
Loudspeaker to Yes or No, and click OK.
----End

7.1.11 How Is a Signal Name Changed

Context


Procedure
Step 1 Log in to the ECC800 WebUI as an administrator.
Step 2 Choose System Settings > Signal Name Modify. The Batch Signal Configuration page is
displayed.
Step 3 Set Device type to ECC800, set Device name to ECC800, and click OK.
Step 4 On the query result tab page, set the new signal name of AI/DI_3 to Smoke and click
Submit.
Step 5 Choose Monitoring > System > ECC800 > Running Parameters > AI/DI_3 Port Settings.
Check that the signal name of AI/DI_3 has been changed to Smoke.
----End
7.1.12 How Should I Link the Smoke Alarm with the Alarm
Beacon over the ECC800 WebUI
Prerequisites
The alarm beacon is connected to the DO port on the ECC800.
Context
This section describes how to set an alarm linkage by linking output dry contact of the smoke
alarm on the multi-functional sensor to the DO2 port.
After the smoke alarm is linked with the alarm beacon, if smoke is detected inside the smart
module, the alarm beacon connecting to the corresponding DO2 port will generate an audible
and visual alarm.
Issue 06 (2020-03-20)
In this example, the smoke sensor is connected to the AI/DI_3 port on the ECC800.
The following procedure describes how to change the signal name of AI/DI_3. Other
signal names can be changed in a similar way.
Copyright © Huawei Technologies Co., Ltd.
7 FAQ
117