Commissioning Ipc6325 Camera (Sd Card Configured) - Huawei FusionModule5000 Commissioning Manual

FusionModule5000 Smart Modular Data Center
Commissioning Guide
----End
Follow-up Procedure
Commission the other cameras by referring to this section.

6.6.5.3.2 Commissioning IPC6325 Camera (SD Card Configured)

Context
If the VCN is not configured and an SD card is chosen, perform the following procedure.
Procedure
Step 1 Log in to the camera WebUI.
1.
2.
Step 2 For details about how to commission cameras and set parameters for them, see the
documentation delivered with the equipment or obtain the documentation by referring to the
"Preparing Documentation" section.
1.
2.
3.
4.
Issue 06 (2020-03-20)
Configure the PC IP address and the camera IP address in the same network segment.
Enter the camera IP address (192.168.0.120 by default) in the address bar of the Internet
Explorer and press Enter.
Enter the preset user name admin and the preset password HuaWei123, and click Log
In.
Preview the site situation in real time and check the camera coverage through videos.
Adjust the lens if necessary.
Set IPv4 address, IPv4 subnet mask, and IPv4 gateway address to the planned values.
Figure 6-33 Basic camera configuration
Format the SD card.
a. Choose Settings > System Configuration > Storage Management.
b. The Storage Management page is displayed, format the SD card.
Set the camera stream type and primary stream parameters. Path: Settings >
Video/Audio/Image > Video Settings.
Copyright © Huawei Technologies Co., Ltd.
6 Commissioning the Management System
90