How To Set And Add The Smoke Detector (Connected To The Ai/Di Port On The Skylight Actuator) - Huawei FusionModule5000 Commissioning Manual

FusionModule5000 Smart Modular Data Center
Commissioning Guide
1.
2.
3.
4.
5.
6.
7.
Step 2 Check functions of water sensors.
Table 7-2 Function check
Check Method
Immerse the water
detection cable in
water.
----End
7.1.3 How to Set and Add the Smoke Detector (Connected to the
AI/DI Port on the Skylight Actuator)
If a smoke sensor is installed, perform the following steps to configure it.
Prerequisites
The smoke detector has been connected to the AI/DI port on the skylight actuator using a
network cable.
To connect the cable for the smoke detector, perform the following steps:
Short-circuit core wires 1 and 8 on the other end of the network cable, and connect the
network cable to the cable delivered with the smoke detector. The following table describes
the cable connection.
Table 7-3 Smoke detector cable connection
Wire of the Network Cable
Core wire 1 (orange-white), core wire 8
(brown)
Issue 06 (2020-03-20)
 In this example, the water sensor is connected to the AI/DI_1 port on the ECC800.
 The default alarm severity of the AI/DI port is Minor. If you want to change the alarm severity, see
How Should I Configure Alarm Parameters.
Log in to the ECC800 WebUI as an administrator.
Choose System Settings > Signal Name Modify. The Batch Signal Configuration
page is displayed.
Set Device type to ECC800, set Device name to ECC800, and click OK.
On the query result tab page, set the new signal name of AI/DI_1 to Leak and click
Submit.
Choose Monitoring > System > ECC800 > Running Parameters > AI/DI_1 Port
Settings.
Set Leak sensor to Enable and click Submit.
Confirm that Leak sensor type is automatically identified as Leak sensor(Rope).
Ensure that Leak power supply is Yes.
Normal Connection Status
Leak DI alarm is generated on
the active alarm screen of the
app or on the WebUI.
Copyright © Huawei Technologies Co., Ltd.
Alarm Clearance Method
Wipe dry the water detection
cable. The alarm disappears
automatically.
Smoke Detector Cable
GND (black)
7 FAQ
107