Huawei FusionModule5000 Commissioning Manual page 81

FusionModule5000 Smart Modular Data Center
Commissioning Guide
Issue 06 (2020-03-20)
Figure 6-19 Adding access users
On the Authorization Information and Term of Authorization tab pages, select access
users whose access permissions are to be set, and set Authorized Device, Authorization
Mode, Cabinet Lock, Start time, and End time.
− Access Actuator: Select the authorized access actuator for the user based on the
actual requirements. For example, select Access Actuator1 on the Access Actuator
tab.
− Authorization mode: Select Card, Fingerprint, Card and password, Card and
fingerprint, Fingerprint and password, or Card, password and fingerprint

For example, if you select Card, password and fingerprint for the authorization mode, the door
can be opened only after you swipe an authorized card first, enter the authorized password (press #
to confirm the password), and then scan the fingerprint.
 The fingerprint information is used only for configuring the access control function and is not used
for other purposes. The fingerprint information is encrypted during transmission in the ECC800 to
ensure that the personal data of users is fully protected.
− Cabinet lock: Select a type on the Cabinet Lock tab page, for example, Smart
module > IT Cabinet1 > E–LOCK1.
− Permission validity period: Set Start date, Expiration date, and Allow door open
period.
Copyright © Huawei Technologies Co., Ltd.
6 Commissioning the Management System
74