Checking Before Powering On The Power Supply And Distribution System; Checking Before Powering On The Cooling System - Huawei FusionModule5000 Commissioning Manual

FusionModule5000 Smart Modular Data Center
Commissioning Guide
Check Item
environment
3.5.2 Checking Before Powering On the Power Supply and
Distribution System
Table 3-4 Checking before powering on the power supply and distribution system
Check Item
SPD status
Circuit breaker status
Short circuit

3.5.3 Checking Before Powering On the Cooling System

Table 3-5 Checklist before power-on of the cooling system
Check Item
Water refill for the
smart cooling
product humidifier
Smart cooling
product signal cable
Issue 06 (2020-03-20)
Operation
and other sundries inside
and outside each cabinet.
Operation
Check the SPD indicator.
 Check the circuit
breaker labels.

Check the circuit
breaker status.
Conduct input and output
short-circuit detection for
power supply and
distribution devices using a
multimeter.
Operation
Check whether the water refill
valve outside the smart module
is open.

Check the connections of
smart cooling product
Copyright © Huawei Technologies Co., Ltd.
3 Preparations for Power-On Commissioning
Expected Result
copper wires and screws) on the top
of each cabinet.
 There is no foreign matter at the
copper bar terminals.

There is no foreign matter on the
switches, in the switch terminal
groove, and between copper bars
above the switches.

There is no foreign matter on the
bottom plate of each cabinet.
Expected Result
If an SPD indicator is green, the
SPD is running properly. If an SPD
indicator is red, the SPD is faulty
and must be replaced immediately.
 Circuit breaker labels are
correct, clear, complete, and
attached properly.

All circuit breakers in the
integrated UPS are OFF.
There is no short circuit.
Expected Result
The water refill valve outside the
smart module is open and water
refill is normal.
Cables are securely connected
and meet the design
19