Commissioning Alarm Notification - Huawei FusionModule5000 Commissioning Manual

FusionModule5000 Smart Modular Data Center
Commissioning Guide
Procedure
Step 1 Log in to the ECC800 WebUI as an administrator.
Step 2 Choose Maintenance > Opening Guide to access the parameter configuring page for the
configuration wizard.
Step 3 Configure related parameters on the page as instructed. For details, see the function
description on the left of the page.
Step 4 After configuring the parameters, click Finish.
Step 5 After confirming that the commissioning Result is normal, enter the Checker Name and
Check Date, and click Configuration Completed.
----End

6.3 Commissioning Alarm Notification

You can set alarm notification by email or SMS as required. Information about a maximum of
20 users who will receive alarm notification can be displayed.
Prerequisites
To implement alarm notification by SMS, the following conditions must be met:

To implement alarm notification by email, the following conditions must be met:

Procedure
Step 1 Choose System Settings > Event Notification.
Step 2 Set the Outbox Setting parameter.
Issue 06 (2020-03-20)
The deployment wizard is displayed when you log in to the ECC800 WebUI for the first time or the
system type is switched.
 In the process, click Previous, Next, and Skip as required.
 To exit before the configuration is complete, click Finish to terminate the configuration directly.
To export the configuration result, click Export Check Result. The export file format is csv.
The ECC800 is configured with a 3G module and supports SIM card access in
2G/3G/4G mode. The 2G card should support the GSM mode, and the 3G/4G card
should support the WCDMA and GSM modes.
The ECC800 is connected to a network with n email server through a WAN port. Both
the Internet and local area network (LAN) are supported.
The ECC800 supports only SMS notification service but not data service by using the 3G module.
Copyright © Huawei Technologies Co., Ltd.
6 Commissioning the Management System
56