Huawei FusionModule5000 Commissioning Manual page 90

FusionModule5000 Smart Modular Data Center
Commissioning Guide


Table 6-24 IP address plan
Device
Camera
VCN
Procedure
Step 1 Connect a network cable between the PC network port and the LAN_1 port (protected by a
security mechanism) on the ECC800.
Step 2 Set the IP address for the IPC6325 camera.
1.
2.
Issue 06 (2020-03-20)
the IPC6325 camera automatically obtains an IP address that is in the same network
segment as the ECC800 IP address.
Before commissioning the IPC6325 camera, set the IP address for the IPC6325 camera
based on customer requirements.
Set the internal and external IP addresses as planned by the customer. The following IP
addresses are just examples.
Internal IP Address
Example: 192.168.248.50; range:
192.168.248.50–192.168.248.199
Example: 192.168.248.55; range:
192.168.248.50–192.168.248.199
Enter https://192.168.248.10 in the address box of the browser and press Enter to access
the WebUI login page. After login, choose System Settings > Video Management.
Under the Search for Video Device IP Address list, click Search.
 Configure the camera IP address and the IP address of the LAN port on the ECC800 in the same
network segment.
 The search timeout interval is 10s. If the search fails, a search failure message is displayed.
 To avoid missing cameras, perform Search for multiple times.
Figure 6-26 Searching for the camera IP address
Copyright © Huawei Technologies Co., Ltd.
6 Commissioning the Management System
External IP Address
Camera external IP
address
VCN external IP address
83