ITW Dynatec DYNAMELT D15 Series Technical Documentation Manual page 88

Adhesive supply unit
Table of Contents

Advertisement

Page 5-12
Revised 1/16
Item Description
Set the pump to the desired mode by pressing MANUAL, OFF (STOP) or AUTO.
• MANUAL: The pump speed is adjusted manually by the operator. If MANUAL is selected
the icon is highlighted green.
• OFF (STOP): The pump is stopped, until AUTO or MANUAL is selected. If OFF is selected
the icon is highlighted red.
• AUTO: The pump speed is controlled via a 0–10VDC signal that is provided by an external
device (pattern control equipment or parent machine input). If AUTO is selected the icon is
5
highlighted green.
A minimum speed is necessary to keep the pump turning in order to maintain a minimum
amount of adhesive pressure through the hose and applicator head.
For instance, if the input signal is 10VDC at 100 meters per minute and the pump
percentage of full speed is 100% (maximum speed), but the system is putting out too much
adhesive, adjusting the MAX pump percentage to 50 will cause the pump to slow down over
the parent machine's entire speed range and adhesive output will be decreased.
Settings Button
Press this button to go to the Extended Pump Mode Settings screen where you can select the
6
Current Pump Mode "Linear Line Speed" or "Pressure Control" and you can go to the
"Automatic Ramp Compensation" screen.
7
Press the arrow icon to go to the next pump screen (ie, Pump 3, etc.).
BACK Button
8
Press to return to the previous screen.
LINE SPEED: The actual (or calculated) line speed is displayed.
9
PRESSURE: The actual pressures are displayed. See explanation under Main Screen point 4.
10
SPEED: The actual (or calculated) pump speed is displayed.
11
V6 DCL Touch Screen Controller for Dynamelt M & D ASUs
ITW Dynatec

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DYNAMELT D15 Series and is the answer not in the manual?

This manual is also suitable for:

Dynamelt d25 seriesDynamelt d45 series

Table of Contents

Save PDF