To Navigate Away From Overview Screen - ITW Dynatec DYNAMELT D15 Series Technical Documentation Manual

ITW Dynatec
D SERIES V6 DCL ASU Manuals
Overview Screen Example
The Overview Screen illustrated below illustrates an example of a typical system. This melter has
two premelt (drop‐in) grids and two hopper heaters for a total of four ASU temperature zones.
The screen also shows six hoses and four pump/ motors. There are additional temperature zones
in this system, not seen on this screen, as indicated by the flashing arrows.
Premelt symbol, showing two
temperature zones
To Navigate Away from the Overview Screen
Press This Button
System Configuration
Menu
Pump
Return
F1, F2, F3, F4
F5
System Status
Hose symbol, showing six
temperature zones
To:
Go to the System Configuration Menu to program the temperature
unit, language, setpoint limitation, hi/ low tolerance, setback
temperature, level control, heat‐up sequence, pump enable
temperature, access code, 0.5 RPM increments, temperature offset,
zone names, power‐on configuration or view the logbook.
Go to the Main Menu screen to program recipes, set‐back mode,
keypad locking and the 7‐day scheduler or to go to the Help Screen
Go to the Pump/ Motor screen to program pump parameters
Return to the previous screen
Go to the temperature zones (use as shortcuts)
Go to the Pump/ Motor screen (alternative method)
Flashing arrows = turn Input Wheel to view more zones
(ie, Applicator and Aux zones),
or push to go back and forth to more zones.
LCD Programming Page 5-5
Revised 10/14
Pump Status
Four pumps are run‐
ning. Their speeds (in
rpms) are shown