Lcd Hmi Programming; Dynacontrol V6 Lcd Interface; In General - ITW Dynatec DYNAMELT D15 Series Technical Documentation Manual

ITW Dynatec
D SERIES V6 DCL ASU Manuals
PROGRAMMING INSTRUCTIONS, V6 LCD FOR D SERIES ASUs
DynaControl CONTROLLER, V.6.00 and Up
DynaControl (DCL) V6 LCD Interface
DynaControl V6 controller technology is available as a liquid crystal display (LCD), which allows an
instant overview of temperature zone and pump status, and with a combination Input Wheel/
Enter Knob to facilitate fast programming. The LCD HMI is the standard controller for the D Series
ASUs.
LCD

In General

Press the Return button to return to the Overview Screen (seen on next page).
This controller utilizes the graphics
or OFF or not‐selected).
When there is no operator activity on a screen for approximately 30 seconds, the controller will
automatically return to the Overview Screen.
Chapter 5, Section 1
Adhesive Application Systems
Adhesive Application Systems
Input Wheel/ Press Knob to Enter
(indicating YES or ON or selected) and
LCD Programming Page 5-1
V6
DynaControl
Return
(indicating NO
Revised 10/14