ITW Dynatec DYNAMELT D15 Series Technical Documentation Manual page 37

ITW Dynatec
D15/D25/D45 V6 DCL ASU Manual #20-63
b. If Pump is in Manual Mode:
i. Select the pump for programming under the Settings column on the Pump Overview Screen.
ii. Set the manual setpoint value (RPM) under Manual Mode Settings.
iii. Select the next pump (if applicable) under the Settings column on the Pump Overview
Screen. Repeat steps i thru iii until all pumps in the system are programmed.
Shut Down Procedures
At the pump screen:
1 .If Pump is in Auto Mode:
a. Press STOP or ALL PUMPS STOP.
b. Turn OFF the Main Disconnect Switch.
2. If Pump is in Manual Mode:
a. Press STOP or ALL PUMPS STOP.
b. Turn OFF the Main Disconnect Switch.
3. If the Scheduler is in use:
Turn OFF the unit with the Control Switch On/Off (ie, on the Main Screen, press the Control but-
ton. Then, at the Control Switch/ Standby Screen, press On/Off).
Note: If the Scheduler is not in operation, use the Main Disconnect Switch to turn the unit OFF to
avoid unexpected ASU activation in the event of a power outage.
Installation Page 3-15
Revised 10/14