Replace The Waste Ink Tank With New One; If A Waste Ink Tank Confirmation Message Appears - MIMAKI TS500P-3200 Operation Manual

Chapter 4 Maintenance
Replace the waste ink
tank with new one
If a Waste Ink Tank Confirmation
Message Appears
Ink used in head cleaning, etc. is stored in the waste ink tank
on the lower right side of the machine. The sensor monitors
the discharged amount of ink in this machine. When that
reaches a specified amount, the machine displays a
confirmation message. (When this message is displayed,
consider the replacement of the waste ink tank.)
Confirmation Message in LOCAL
1
The confirmation message is displayed.
• The following message will be displayed.
"Waste ink near full"
"Waste ink full"
"Waste ink tank none"
2
Check the state of the waste ink tank
Replace the waste ink tank on the right
side of machine with another
In the waste ink tank of the right side of the machine, the
ink and cleaning solution discharged around the head at
the printing or head cleaning will be accumulated.
When replacing the waste ink tank, please perform the
following tasks.
1
Open the waste ink tank cover.
• Remove the screw attaching to the waste ink tank
cover and open the cover to the front.
2
Lift the waste ink tank a little.
• Lift the waste ink tank up to the position where it
does not hit the stopper.
4-20
Stopper
3
Take out the waste ink tank.
(1) Hold the handle of the waste ink tank and
pull it out to the front.
(2) Raise the waste ink tank and take it out.
• Put a cap on the waste ink tank removed.
4
Replace the waste ink tank.
(1) Prepare a new waste ink tank (SPC-0197).
(2) Hold the handle of the waste ink tank and
insert it along the rail.
(3) Raise the waste ink tank.
Rail
Cap
Waste ink