Rotary Cutter (B-8204-Qm; Applicable Model; Packing List; Installation Procedure - Toshiba TEC B-SX4T Series Maintenance Manual

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
4.13 ROTARY CUTTER (B-8204-QM-R)
1. Follow all manual instructions. Failure to do so could create safety hazards such as fire or electrocution.
• Manual instructions must be followed when installing option kits or adding cables to avoid system failures
and to insure proper performance and operation
• Failure to follow manual instructions or any unauthorized modifications, substitution or change to this
product will void the limited product warranty.
2. Turn the power off and disconnect the power cord before installing the rotary cutter module.
3. Be careful not to injure your fingers when installing the swing cutter module.
4. Be careful not to pinch your fingers or hands with the covers.

4.13.1. Applicable Model

This optional kit is the rotary cutter module, which is intended for the following models:
B-SX4T-QM-R Series, B-SX5T-QM-R Series
NOTE: When using the Rotary Cutter to the B-SX4T Series, be sure to install the Ribbon Saving Module (B-
9904-R2-QM-R). Failure to do this may cause a paper jam or ribbon error.

4.13.2. Packing List

All the following parts are supplied with the kit. Make sure you have all items shown below.
Cutter Unit (1 pc.)
Cord Bush (1 pc.)
(For B-SX4 only)

4.13.3 Installation Procedure

4.13.3.1 Installing the Rotary Cutter Unit on the B-SX4T Series
1) Turn the power off and disconnect the power cord.
2) Remove the two black screws to detach the front plate.
NOTE: Retain the two black screws and front plate.
Mantenimiento Periféricos Informáticos C/Canteras,15 28860 Paracuellos de Jarama Madrid Tel: 91 748 16 04 www.mpi.com.es
Cutter Cover (1 pc.)
Print Head Cleaner (1 pc.)
(P/No.: FMQB0051601)
Black Screws
WARNING!
Cutter Drive Unit (1 pc.)
•
Installation Manual (1 copy)
•
SM-4x8 Screw (6 pcs.)
Front Plate
4-79
EO18-33012B
4.13 ROTARY CUTTER (B-8204-QM-R)
Harness Ass'y
(2-pin & 9-pin) (1 pc.)