Attaching The Antenna To The Antenna Cover Or Antenna Frame; Attaching The Rfid Module To The Rfid Plate - Toshiba TEC B-SX4T Series Maintenance Manual

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT

4.11.3 Attaching the Antenna to the Antenna Cover or Antenna Frame

Basically, the Antenna is attached to the Antenna Cover. However, read/write of RFID tag may
become more accurate when the Antenna is attached to the Antenna Frame. When attaching the
Antenna to the Antenna Cover, use the PT-3x6 Screws. And use two of the SMW-3x6 Screws when
attaching it to the Antenna Frame. Place the Antenna in the orientation as shown in the pictures below.
When they are installed in the printer, the pattern side of the Antenna faces up and the Antenna Cable
is positioned at the printer frame side.

4.11.4. Attaching the RFID Module to the RFID Plate

1) Put the Nylon Washer onto the SMW-2x10 Screw. Do the same to the other SMW-2x10 Screw.
2) Place the RFID Module on the RFID Plate as shown in the picture below. Insert the Spacers
under the RFID Module, and secure it to the RFID Plate with the SMW-2x10 Screws.
RFID Plate
Mantenimiento Periféricos Informáticos C/Canteras,15 28860 Paracuellos de Jarama Madrid Tel: 91 748 16 04 www.mpi.com.es
Antenna Cover
Antenna Frame
SMW-2x10 Screw
SMW-2x10 Screw
Nylon Washer
Spacer
Antenna Cover
Antenna
Antenna Frame
Antenna
4-59
4.11 RFID MODULE (B-9704-RFID-H1-QM)
PT-3x6 Screw
SMW-3x6 Screw
Nylon Washer
RFID Module
SMW-2x10 Screw
EO18-33012B
Nylon Washer
Spacer