Toshiba TEC B-SX4T Series Maintenance Manual page 37

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
4) Secure the RSV PC board to the printer with the locking supports.
NOTE: Do not push the center of the RSV PC board when attaching it to the printer. Doing so may
break the PC board. Hold the locking supports and push them into the holes for securing the
RSV PC board.
5) Insert folded tag paper (1.5-mm thick) between the print head and the platen, and then turn the
head lever to Lock position. Insert the head up arm into the plunger of the solenoid. While
holding down the head up arm slightly, lift the solenoid. Secure the solenoid to the frame with the
two SM-4x8 screws keeping the solenoid in contact with the spacer.
Head Up Arm
Mantenimiento Periféricos Informáticos C/Canteras,15 28860 Paracuellos de Jarama Madrid Tel: 91 748 16 04 www.mpi.com.es
Holes for securing the RSV PC Board
Spacer
Solenoid
RSV PC Board
Locking Support
Plunger
4-20
4.4 RIBBON SAVING MODULE (B-9904-R/R2-QM)
SM-4x8 Screw
Frame
EO18-33012B