Parameter Setting And Operation Check For The Rfid Module - Toshiba TEC B-SX4T Series Maintenance Manual

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
8) An FCC sticker is supplied with the B-9704-RFID-U1-US model, and a CE sticker is supplied with
the B-9704-RFID-U1-EU/EU-R model, respectively.
After installing the RFID module in the printer, please attach the sticker to the specified location on
the printer.
Location to attach the sticker (on the back of a printer)

4.10.6 Parameter Setting and Operation Check for the RFID Module

After installing the RFID Module in the printer, set the parameters for the RFID and perform an
operation check by using the following procedures. For details, please refer to the Maintenance
Manual.
1) Start the printer in the System Mode, and check the program version. When the program version
is V3.1 or older, go to Step 2). When the program version is V4.1 or greater (US/EU model) or
V4.4 or greater (EU-R model), go to Step 3).
2) When the program version is V3.1 or older, upgrade it to V3.2 or greater in the following order.
Please obtain the latest firmware from
http://barcode.toshibatec.co.jp/Ris/products/barcode/support/en/contents/software/index.html
(1) Print the Maintenance Counter/Parameter Setting to keep the record of the printer's
parameter settings. (Refer to Section 5.3.)
(2) Download the firmware from the above web site, and upgrade the firmware version of the
printer. (Refer to Section 7.)
(3) Perform a Parameter Clear. (Refer to Section 5.8.)
(4) Return the all parameter settings except for RFID Module to the former ones.
3) Change the parameter setting of the RFID Module from "NONE" to "U1". Choosing "NONE"
or "H1" results in NG (No good) at the self diagnostic test even if the RFID Module is properly
connected.
Mantenimiento Periféricos Informáticos C/Canteras,15 28860 Paracuellos de Jarama Madrid Tel: 91 748 16 04 www.mpi.com.es
4.10 RFID MODULE (B-9704-RFID-U1-US/EU/EU-R)
FCC Sticker or CE Sticker
4-54
EO18-33012B
(Revision Date: Feb. 15, 2007)