4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
4.22.3.3 Attaching the Antenna Frame and the Antenna Ass'y
This section describes the procedure for attaching the Antenna Frame and the Antenna Ass'y.
When short-pitch tags (20 mm) are used, the procedure is different from the following. Skip step (1) and go
to step (2).
(1)
When using RFID tags other than short-pitch type:
1.
Raise the Print Head Block, and slide the Antenna Frame into the printer as shown below. Make the
protruding screw shaft of the printer pass through the slit of the Antenna Frame. Also, make the Shaft
of the printer fit in the Cut of the right side of Antenna Frame.
Slit
Mantenimiento Periféricos Informáticos C/Canteras,15 28860 Paracuellos de Jarama Madrid Tel: 91 748 16 04 www.mpi.com.es
Antenna Frame
Screw Shaft
Shaft
4-138
(Revision Date Apr. 24, 2008)
4.22 RFID MODULE (B-SX704-RFID-U2-EU-R)
Antenna Frame
Cut
EO18-33012B