Toshiba TEC B-SX4T Series Maintenance Manual page 34

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
13) Secure the strip sensor (LED) and strip sensor (Tr) to the printer with the SM-4x8B screws.
14) Connect the shorter harness of the strip sensor (Tr) to the strip sensor harness (for LED).
Strip Sensor
(Tr)
Shorter Harness of the Strip
Sensor Harness (for Tr)
15) Fix the connected strip sensor harness (for LED) to the base with the cable clamp. While passing
the other strip sensor harness through the cut and the bush, reassemble the operation panel ass'y
to the printer. Then pass the strip sensor harness over the tab on the back of the operation panel
ass'y.
Operation
Panel Ass'y
Tab
NOTE: Be careful not to pinch the strip sensor harnesses by the operation panel.
Mantenimiento Periféricos Informáticos C/Canteras,15 28860 Paracuellos de Jarama Madrid Tel: 91 748 16 04 www.mpi.com.es
SM-4x8B Screw
Strip Sensor
Harness (for LED)
Bush
Strip Sensor (Tr)
Strip Sensor Harness (for LED)
4-17
EO18-33012B
4.3 STRIP MODULE (B-9904-H-QM)
SM-4x8B Screw
Strip Sensor (LED)
Strip Sensor Harness
Cut
Cable Clamp