Toshiba TEC B-SX4T Series Maintenance Manual page 192

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
Continued from the previous page.
<10>RFID
TAG NONE
[PAUSE]
<10>RFID
ERR CHK OFF
[PAUSE]
<10>RFID
ISSUE RETRY
[PAUSE]
<10>RFID
R CYCLE CNT 5
[PAUSE]
Continued to the next page.
Mantenimiento Periféricos Informáticos C/Canteras,15 28860 Paracuellos de Jarama Madrid Tel: 91 748 16 04 www.mpi.com.es
RFID tag type setting menu is displayed.
Choose "EPC C1 Gen2: 24" with the [FEED] or [RESTART] key.
[RESTART]
[FEED]
Press the [PAUSE] key.
RFID error tag detection menu is displayed. Choose whether to perform an error tag
detection or not with the [FEED] or [RESTART] key.
[RESTART]
[FEED]
ON: A tag is read before writing data on it, and data is written on the tag only when the
header data is "A5A5".
OFF: Though a tag is read before writing data on it, data write is always performed
whatever data has been set as the header data.
Press the [PAUSE] key.
Max. number of issue retries setting menu is displayed.
3
Set a maximum number of retries to issue an RFID tag.
When issuing an RFID tag failed, the printer prints the error pattern, and retries to issue the
tag for up to specified number of times. If the printer does not succeed even after having
retried for the max. times, the printer stops, resulting in an error.
Choose the max. number of retries with the [FEED] or [RESTART] key.
[RESTART]
[FEED]
Press the [PAUSE] key.
Max. number of read retries setting menu is displayed.
Set a maximum number of retries to read an RFID tag.
The printer retries to read the data in an RFID tag for up to specified number of times. If the
timeout period expired before the max. number retries have been done, the printer stops the
retries at the time.
Whenever the printer writes data onto an RFID tag, the tag is read first. The max. number of
retries set by this parameter becomes also effective in this pre-read.
Choose the max. number of retries with the [FEED] or [RESTART] key.
[RESTART]
[FEED]
Press the [PAUSE] key.
4.23 RFID MODULE (B-SX704-RFID-U2-AU-R)
NONE: When a tag type is not selected.
EPC C1 Gen2: 24
OFF: An error tag detection is not performed. (Usually,
choose OFF.)
ON: An error tag detection is performed.
255
•
•
•
3 (Default)
•
•
0
255
•
•
•
5 (Default)
•
•
0
4-175
EO18-33012B
(Revision Date May 29, 2008)