Toshiba TEC B-SX4T Series Maintenance Manual page 114

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
Fix the connected strip sensor harness (for LED) to the base with the cable clamp. While passing the
other strip sensor harness through the cut and the bush, reassemble the operation panel ass'y to
the printer. Then pass the strip sensor harness over the tab on the back of the operation panel
ass'y.
Strip Sensor Harness
Operation Panel
Ass'y
Tab
NOTE: Be careful not to pinch the strip sensor harnesses by the operation panel.
Mantenimiento Periféricos Informáticos C/Canteras,15 28860 Paracuellos de Jarama Madrid Tel: 91 748 16 04 www.mpi.com.es
Cut
Strip Sensor (Tr)
Strip Sensor Harness (for LED)
Bush
Tab on the back of the
Operation Panel Ass'y
Bush
4-97
EO18-33012B
4.14 STRIP MODULE (B-9904-H-QM-R)
Cable Clamp
Strip Sensor Harness
(for LED)
Strip Sensor Harness
Cut
Cable Clamp