Toshiba TEC B-SX4T Series Maintenance Manual page 33

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
10) Connect the longer harness of the rewind full sensor (Tr) and the rewinder harness to CN4 and
CN15 on the Main PC board, respectively.
CN4
NOTES:
1. You should change the selection switch setting depending on the issue mode. Improper setting
may affect the print quality.
STANDARD/PEEL OFF (STRIP):
REWINDER:
For the cut mode, the selection switch can be set to
either position.
2. The backing paper can be wound directly onto the Take-up
Spool or a paper core.
When using the Take-up Spool, detach the Holder Stopper
by removing the B-3x4 screw. Otherwise, it may be difficult
to pull out the wound backing paper roll.
When using a paper core, put the core on the Take-up
Spool with the Holder Stopper on it, and Attach the top
edge of the backing paper to the core with adhesive tape.
The Take-up Clip is not necessary.
This winding method is applicable to the Built-in Rewinder
mode.
11) Open the print head block. (Refer to section 3.3.)
12) Fix the longer harness of the rewind full sensor and the rewinder harness under the Main PC
board with the cable clamp.
Main PC Board
Mantenimiento Periféricos Informáticos C/Canteras,15 28860 Paracuellos de Jarama Madrid Tel: 91 748 16 04 www.mpi.com.es
Main PC Board
Longer Harness of the
Rewind Full Sensor (Tr)
Batch or strip mode
Built-in rewinder mode
Longer Harness of the
Rewind Full Sensor (Tr)
Selection Switch
Cable Clamp
4-16
EO18-33012B
4.3 STRIP MODULE (B-9904-H-QM)
CN15
Rewinder Harness
Holder Stopper
B-3x4 Screw
Take-up Spool
Take-up Clip
Rewinder Harness