Toshiba TEC B-SX4T Series Maintenance Manual page 83

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
8) Connect the RFID Cable of the RFID Module to CN14 on the Main PC Board.
Main PC Board
RFID Cable
9) Connect the Antenna Cable to the RFID Module until it clicks. To prevent the Antenna Cable from
being caught in the Side Panel (L) or Fan Motor, fold the cable and fix it with the two Cable
Clamps.
10) Attach the Side Cover (L), the Front Plate, the Platen Holder Cover, the Platen, and the Strip Plate
in the reverse order of removal. Refer to Section 4 to program the RFID Module and perform an
operation check.
NOTE: When attaching the Side Cover (L), carefully lead the Fan Motor Harness so that it does not get
sucked into the Fan Motor.
Mantenimiento Periféricos Informáticos C/Canteras,15 28860 Paracuellos de Jarama Madrid Tel: 91 748 16 04 www.mpi.com.es
CN14
RFID Module
Connector
Cable Clamp
4.11 RFID MODULE (B-9704-RFID-H1-QM)
4-66
EO18-33012B
RFID Module
Mark
Antenna
Cable