Removing The Cutter Motor And Paper Door Assembly - Toshiba 1NR Hardware Service Manual

Removing and replacing FRUs
Notes:
1. Notice that one end of the cable is longer than the other. The longer end should
2. Do not reverse flip the cable during installation.
3. An improperly installed cable will result in no communication between the logic
To replace the thermal printhead flat cable, complete the following step:
1. Orient the cable so the longest end is facing up and the blue stripe facing away
2. Slide the long end of the cable into the printer unit just under the printhead
3. Route the rest of the cable through the printer unit frame toward the logic card.
4. Connect the cable to the printhead; then install the printhead (see "Removing
5. Connect the opposite end of the cable to the logic card; then replace the logic

Removing the cutter motor and paper door assembly

Follow these steps to remove the cutter motor and paper door assembly:
1. Follow the steps in "Removing the logic card" on page 60 to access the cutter
2. Remove the two screw that hold the cutter motor to the unit and remove the
62
SureMark Hardware Service
Note: Be sure to note the orientation of the flat cable, paying close attention to
the blue stripe on each end of the cable and the length of each leg of the
cable.
be installed into the printhead.
card and the thermal print head.
from you.
mount.
the thermal printhead" on page 58 for information on how to replace the
printhead).
card (see "Removing the logic card" on page 60 for information on how to
replace the logic card).
motor and paper door assembly cable connector.
Note: Do not disconnect any cables other than the cutter motor and paper door
assembly cable from the logic card.
cutter motor.