Toshiba TEC B-SX4T Series Maintenance Manual page 28

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
7) Insert the harness ass'y into the hole in the main frame. Fit the bush into the hole.
8) Connect the 9-pin connector of the harness ass'y to CN15, and 2-pin connector to CN18 on the
Main PC board, respectively.
9) Open the print head block. (Refer to section 3.3.)
10) Connect the four harnesses of the cutter unit to CN8, CN10, CN11 and CN12 on the cutter drive
unit.
Cutter Unit
Mantenimiento Periféricos Informáticos C/Canteras,15 28860 Paracuellos de Jarama Madrid Tel: 91 748 16 04 www.mpi.com.es
Main Frame
Harness Ass'y
Main PC Board
Print Head Block
CN18 (2 pins)
CN15 (9 pins)
Cutter Drive Unit
CN11
4-11
EO18-33012B
4.2 ROTARY CUTTER (B-8204-QM)
Hole
Harness Ass'y
CN12
CN8
CN10