Applicable Model; Packing List - Toshiba TEC B-SX4T Series Maintenance Manual

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
4.11 RFID MODULE (B-9704-RFID-H1-QM/QM-R)
NOTES:
1. An RFID tag chip or the print head may be damaged when the print head passes over the chip.
This can be prevented by using the ribbon saving module (standard feature for the B-SX5T and optional for
the B-SX4T). The print head is lifted by the ribbon saving module when it passes over the chip to prevent it
from touching the chip. The print head is lifted by approximately 1 mm from the platen.
2. When an RFID label or tag is used in cut issue mode, care must be taken not to cut an antenna of the RFID
tag or an IC chip in order not to damage the cutter.
3. When using the RFID module together with a cutter or strip module, be sure to install the RFID module first.
When the B-4205-QM swing cutter has been installed, remove the cutter unit before installing the RFID
module.
When the B-8204-QM rotary cutter has been installed, remove the cutter unit and cutter drive unit before
installing the RFID module.
When the B-9904-H-QM strip module has been installed, remove the rewinder guide plate and strip sensors
(Tr and LED) before installing the RFID module. (The strip module is standard feature of the B-SX5T series.)

4.11.1 Applicable Model

This optional device is intended for the following models:
The B-9704-RFID-H1-QM model is intended for the following models:
B-SX4T-GS10-QQ/QQ-US/QP, RFID Ready printer (Serial No. 2604Wxxxxxx or later)
B-SX5T-TS10-QQ/QQ-US/QP, RFID Ready printer (Serial No. 2604Wxxxxxx or later)
The B-9704-RFID-H1-QM-R model is intended for the following models:
B-SX4T-GS10-QQ/QQ-US/QP, RFID Ready printer (Serial No. 2604Wxxxxxx or later)
B-SX5T-TS10-QQ/QQ-US/QP, RFID Ready printer (Serial No. 2604Wxxxxxx or later)
B-SX4T-GS20-QM-R, B-SX5T-TS22-QM-R
An RFID Ready printer can be identified by the model name sticker on the front of the printer.
The countries where the use of this device is allowed are as follows:
Model Name
B-9704-RFID-H1-
QM/QM-R

4.11.2 Packing List

All the following parts are supplied with the kit. Make sure you have all items shown below.
Antenna Cover
Ribbon Guide
Mantenimiento Periféricos Informáticos C/Canteras,15 28860 Paracuellos de Jarama Madrid Tel: 91 748 16 04 www.mpi.com.es
Frequency Band
HF (13.56MHz)
Parts
Austria, Belgium, Cyprus, Czech, Denmark, Estonia,
Germany, Greece, Finland, France, Hungary, Ireland,
Italy, Latvia, Lithuania, Luxemburg, Malta, Poland,
Portugal, Slovakia, Slovenia, Spain, Sweden, the
Netherlands, and U.K.
Quantity
Antenna Frame
1 pc.
Bush
1 pc.
4-56
(Revision Date: Jan. 19, 2007)
4.11 RFID MODULE (B-9704-RFID-H1-QM/QM-R)
Applicable Countries
Parts
EO18-33012B
Quantity
1 pc.
1 pc.