Toshiba TEC B-SX4T Series Maintenance Manual page 29

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
11) Fit the two tabs of the cutter drive unit into the notches, and then fix the cutter unit with the three
SM-4x8 screws.
SM-4 x 8 Screw
Notch
12) Attach the cutter cover to the cutter unit with the two screws so that the tab of the cutter cover
turns on the cutter cover open switch.
NOTES: 1. Be careful not to pinch the cutter harness by the cutter cover.
2. Make sure that the anti-static brush is protruding from the media outlet.
Cutter Cover
Anti-static
Brush
Media Outlet
13) Close the print head block and ribbon shaft holder plate.
NOTE: DO NOT excessively push down the print head block to close it. Doing so may cause a
failure of the print head block or damage to the print head.
14) Reassemble the side panel (L) and close the top cover. Finally check the cutter operation.
Mantenimiento Periféricos Informáticos C/Canteras,15 28860 Paracuellos de Jarama Madrid Tel: 91 748 16 04 www.mpi.com.es
Tab
Cutter Cover Open Switch
Screw
4-12
EO18-33012B
4.2 ROTARY CUTTER (B-8204-QM)
Cutter Unit
SM-4 x 8 Screw
Tab
Notch
Cutter Cover
Tab