Rotary Cutter (B-8204-Qm) - Toshiba TEC B-SX4T Series Maintenance Manual

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT

4.2 ROTARY CUTTER (B-8204-QM)

Be careful not to injure your fingers when installing the cutter unit.
This optional device is used for cut print, which cannot be used together with either B-4205-QM or B-
9904-H-QM.
When this cutter is used together with an RFID module, be sure to install the RFID module prior to the
cutter.
All the following parts are supplied with the kit. Make sure you have all items shown below.
Cutter Unit (1 pc.)
Cord Bush (1 pc.)
• Installation Manual (1 copy)
• SM-4x8 Screw (6 pcs.)
NOTES:
1. When using the rotary cutter on the B-SX4T series, the print speed of 10"/sec. is not supported. Also,
when using the rotary cutter, be sure to install the ribbon saving module (B-9904-R-QM). Failure to do
this may cause a paper jam or ribbon error. (For the installation procedure, please refer to Section 4.9.)
2. The B-8204-QM with the serial number of 2805Dxxxxxx or earlier cannot be installed on an RFID-ready
printer (2804Sxxxxxx or later) without changing some parts of the cutter drive unit. For the parts change
procedure, refer to the following:
1) Release the four Locking Supports to remove the Rotary Cutter PC Board from the frame.
NOTE: Locking supports are not used. Please discard them.
Mantenimiento Periféricos Informáticos C/Canteras,15 28860 Paracuellos de Jarama Madrid Tel: 91 748 16 04 www.mpi.com.es
Cutter Blade
Cutter Cover (1 pc.)
Print Head Cleaner (1 pc.)
(P/No.: FMQB0051601)
Cutter Drive Unit
WARNING!
Cutter Drive Unit (1 pc.)
B-SX Cutter Paper Guide C
(1 pc.)
Frame
4- 7
EO18-33012B
4.2 ROTARY CUTTER (B-8204-QM)
Harness Ass'y
(2-pin & 9-pin) (1 pc.)
Rotary Cutter PC Board