Rotary Cutter (B-Ex204-R-Qm-R) - Toshiba B-EX4 SERIES Maintenance Manual

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT

4.2 ROTARY CUTTER (B-EX204-R-QM-R)

Be careful not to injure your fingers when installing the cutter unit.
All the following parts are supplied with the kit. Make sure you have all items shown below.
Description
Cutter Unit
Cutter Cover
Cutter Drive Unit
Harness Ass'y (2-pin & 9-pin)
Installation Manual
NOTES:
1. When using the rotary cutter on the B-E4T series, the print speed of 10"/sec. is not supported. Also,
when using the rotary cutter, be sure to install the ribbon saving module (B-EX904-R-QM-R). Failure to
do this may cause a paper jam or ribbon error. (For the installation procedure, please refer to Section
4.9.)
2. The B B-EX204-R-QM-R with the serial number of 2805Dxxxxxx or earlier cannot be installed on an
RFID-ready printer (2804Sxxxxxx or later) without changing some parts of the cutter drive unit. For the
parts change procedure, refer to the following:
1) Release the four Locking Supports to remove the Rotary Cutter PC Board from the frame.
NOTE: Locking supports are not used. Please discard them.
2) Disassemble the frame into 3 parts.
SMW-3x6
3) Replace the Rotary Cutter Guide Plate B and the Rotary Cutter Guide Plate C with the Rotary Cutter
Frame A and Rotary Cutter Frame B, respectively.
WARNING!
Q'ty/Unit
1
Cord Bush
1
Print Head Cleaner
1
B-SX Cutter Paper Guide
1 SM-4x8 Screw
1
Frame
Cutter Drive Unit
SMW-4x8
Rotary Cutter PC Board Cover
(To be used later.)
4- 4
4.2 ROTARY CUTTER (B-EX204-R-QM-R)
Description
Rotary Cutter Guide Plate B
Rotary Cutter Guide Plate C
EO18-33027
Q'ty/Unit
1
1
1
5
Rotary Cutter PC Board