Toshiba TEC B-SX4T Series Maintenance Manual page 10

1. UNPACKING
5) Open the top cover and remove the five pieces of tape. And then, open the ribbon shaft holder
plate to remove the ribbon shaft pad from the printer.
Tape
6) In case of the B-SX5T series, take out the rewinder guide plate and two SMW-3x8 screws from
the printer inside. Also, remove the tape from the rewinder unit in the printer.
Rewinder Guide Plate
NOTE: For the installation procedure of the rewinder guide plate, refer to Section 4.3.
Mantenimiento Periféricos Informáticos C/Canteras,15 28860 Paracuellos de Jarama Madrid Tel: 91 748 16 04 www.mpi.com.es
Tape
OPEN
Ribbon Shaft Holder Plate
Tape
Top Cover
Ribbon Shaft Pad
Rewinder
1- 2
EO18-33012B
1.1 PROCEDURE
Tape
Tape
SMW-4x8 Screw