Toshiba TEC B-SX4T Series Maintenance Manual page 102

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
13) Raise the print head block until it stops.
Stopper
14) Remove the two SMW-4x8 screws that secure the strip sensors (TR) and (LED).
15) Release the strip sensor (LED) harness from the cable clamp, and disconnect it from the shorter
harness of the strip sensor harness (TR).
Strip Sensor (Tr)
Shorter Harness of the Strip
Sensor Harness (for Tr)
Mantenimiento Periféricos Informáticos C/Canteras,15 28860 Paracuellos de Jarama Madrid Tel: 91 748 16 04 www.mpi.com.es
SMW-4x8B Screw
Strip Sensor Harness
(for LED)
4-85
EO18-33012B
4.13 ROTARY CUTTER (B-8204-QM-R)
Print Head Block
SMW-4x8B Screw
Strip Sensor (LED)
Cable Clamp