Toshiba TEC B-SX4T Series Maintenance Manual page 153

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
17. Rotate the Ribbon Guide Shaft so that its D-cut is in the same orientation with the Ribbon Guide's D-
cut. Without doing this, the Ribbon Guide cannot be fit in the Print Head Block.
Ribbon Guide's D-cut
18. Fit the Ribbon Guide including the Ribbon Guide Shaft in the Print Head Block, and secure it to the
Head Side Plate with the SMW-2.6x6 screw. Temporarily secure the Head Side Plate to the Print
Head Block with the SMW-3ｘ6 Screw and the SMW-4ｘ8 Screw. Be sure to fit the locating pins
provided on the other side of the Ribbon Guide into the locating holes of the Print Head Block.
Locating Hole (A)
Print Head Block
Mantenimiento Periféricos Informáticos C/Canteras,15 28860 Paracuellos de Jarama Madrid Tel: 91 748 16 04 www.mpi.com.es
Double Sems Screw
SMW-3x6
Head Side Plate
Locating Pin(B)
Locating Hole (B)
Ribbon Guide
Double Sems Screw
SMW-4x8
Locating Pin (A)
4-136
(Revision Date Apr. 24, 2008)
4.22 RFID MODULE (B-SX704-RFID-U2-EU-R)
Ribbon Guide Shaft's D-cut
Double Sems Screw
SMW-2.6x6
Ribbon Guide
EO18-33012B
Ribbon
Guide