Ribbon Saving Module (B-9904-R2-Qm-R); Applicable Model; Packing List - Toshiba TEC B-SX4T Series Maintenance Manual

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT

4.15 RIBBON SAVING MODULE (B-9904-R2-QM-R)

1. Follow all manual instructions. Failure to do so could create safety hazards such as fire or
electrocution.
•
Manual instructions must be followed when installing option kits or adding cables to avoid
system failures and to insure proper performance and operation.
•
Failure to follow manual instructions or any unauthorized modifications, substitution or
change to this product will void the limited product warranty.
2. Turn the power OFF and disconnect the power cord before installing the ribbon saving module.
3. Be careful not to pinch your fingers or hands with the covers.
NOTE: The B-9904-R2-QM Ribbon Saving Module is available only with Firmware V1.2A or later. Please
be careful that the earlier firmware version does not support it.

4.15.1 Applicable Model

This optional device is the ribbon saving module, which is intended for the following models:
B-SX4T-QM-R Series

4.15.2 Packing List

All the following parts are supplied with the kit. Make sure you have all items shown below.
Solenoid (1 pc.)
Cable Clamp (1 pc.)
Mantenimiento Periféricos Informáticos C/Canteras,15 28860 Paracuellos de Jarama Madrid Tel: 91 748 16 04 www.mpi.com.es
WARNING!
Power Switch
RSV PC Board (1 pc.)
Locking Support (3 pcs.)
4-100
4.15 RIBBON SAVING MODULE (B-9904-R2-QM-R)
Power Cord
Solenoid Harness (1 pc.)
•
Installation Manual (1 copy)
•
SM-4x8 Screw (2 pcs.)
EO18-33012B