Toshiba TEC B-SX4T Series Maintenance Manual page 134

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
9) Tighten the two M-3x5 screws on the LAN interface board that were loosened previously. (Refer to
Caution)
10) Secure the LAN interface board to the PCB support plate (when connecting to the Main PC board)
or PCB attachment plate (when connecting to the PCMCIA interface board) with the SM-3x6
screw.
When connecting to the Main PC Board
M-3x5 Screw
When connecting to the PCMCIA Interface Board
M-3x5 Screw
11) When installing the LAN interface board only, attach a blind plate A with the SM-3x6 screws to the
printer back, which were removed in Step 5, to cover the unused slot.
Please note that "LU" and "P" are printed on the blind plate A, as shown below.
Attach the blind plate A with the mark of "LU" positioned topside. It cannot be attached in an
improper orientation.
SM-3x6 Screw
12) Attach the side panel (L) back to the printer in the reverse order of removal.
NOTE: Precaution for the LAN cable connection
When connecting a LAN cable with the hooded connectors to the LAN interface board, it may
not be connected depending on the shape of the hood. In this case, move aside the hood,
connect the cable, and return the hood to the former position.
Mantenimiento Periféricos Informáticos C/Canteras,15 28860 Paracuellos de Jarama Madrid Tel: 91 748 16 04 www.mpi.com.es
4.18 LAN INTERFACE BOARD (B-9700-LAN-QM-R)
Blind Plate A
4-117
EO18-33012B
PCB Support
Plate
SM-3x6 Screw
PCB Attachment
Plate
SM-3x6 Screw
Mark of "LU"
Blind Plate A
LAN Interface
Board