Toshiba TEC B-SX4T Series Maintenance Manual page 19

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
1) Turn the power off and disconnect the power cord.
2) When the printer is used in the batch or strip mode:
Remove the two black screws to detach the front plate.
NOTE: Retain the two black screws and front plate.
When the printer is used in the built-in rewinder mode:
Open the top cover, remove the two SMW-4x8 screws, and detach the rewinder guide plate
from the printer.
Rewinder Guide
SMW-4x8
3) Remove the side panel (L). (Refer to Section 3.2.)
4) Remove the operation panel ass'y. (Refer to Section 3.4.)
5) Open the print head block. (Refer to Section 3.3.)
6) Remove the two SMW-4x8 screws that secure the strip sensors (TR) and (LED).
7) Release the strip sensor (LED) harness from the cable clamp, and disconnect it from the
shorter harness of the strip sensor harness (TR).
Strip Sensor (TR)
Shorter Harness of the Strip
Sensor Harness (for TR)
Mantenimiento Periféricos Informáticos C/Canteras,15 28860 Paracuellos de Jarama Madrid Tel: 91 748 16 04 www.mpi.com.es
Plate
SMW-4x8 Screw
Strip Sensor Harness
(for LED)
4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
Black Screws
SMW-4x8
Cable Clamp
4- 2
EO18-33012B
SMW-4x8 Screw
Strip Sensor (LED)