Toshiba TEC B-SX4T Series Maintenance Manual page 78

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
EO18-33012B
4.11 RFID MODULE (B-9704-RFID-H1-QM)
6) Remove the following three screws.
SMW-3x6 Screw
SMW-4x8 Screw
7) Remove the Platen Frame Top from the printer.
Platen Frame Top
8) Remove the four screws from the side of the Print Head Block, slightly pull the Head Side Plate,
and remove the two Ribbon Guide Shafts.
Head Side Plate
SMW-4x8 Screw
SMW-3x6 Screw
Ribbon Guide Shaft
SMW-2.6x6 Screw
NOTE: One of the removed Ribbon Guide Shafts and SMW-2.6x6 Screws are re-used when
attaching the Ribbon Guide. Keep the unused ones for future use.
4-61
Mantenimiento Periféricos Informáticos C/Canteras,15 28860 Paracuellos de Jarama Madrid Tel: 91 748 16 04 www.mpi.com.es