Cutter Module (B-4205-Qm) - Toshiba B-570 SERIES Owner's Manual

3. INSTALLATION PROCEDURE FOR THE OPTIONAL EQUIPMENT

3.2 CUTTER MODULE (B-4205-QM)

Description
Cutter Unit
Cutter Cover
Take-up/Cutter Harness
NOTE: For the B-570 series, the take-up/cutter harness enclosed with the B-4205-QM is not used but
the take-up harness connected to CN2 on the PWM PC board.
1. Remove the top cover and left side cover. (See Fig. 2-1.)
2. Remove the I/F PC board. (See Fig. 2-2.)
3. Remove the front plate. (See Fig. 2-6.)
4. Remove the screw (SM-4x8B) and two connectors to detach the operation panel.
5. Unclamp and disconnect the connector for the strip sensor from CN6 on the CPU PC board.
6. Remove the SM-4x6B screw to detach the strip sensor (LED)/(Tr).
Connector (CN6)
CPU PC Board
Q'ty/Unit
1 Cutter Attaching Screw
1 Screw (FL-4x6)
1 Cleaner
Strip Sensor (Tr)
Clamp
3-3
3.2 CUTTER MODULE (B-4205-QM)
Description
Screw (SM-4x8B)
Connector
Operation Panel
Screw (SM-4x6B)
EM18-33010A
(Revision Date: Feb. 10, 2000)
Q'ty/Unit
2
1
1
Fig. 3-3
Strip Sensor (LED)
Fig. 3-4