Toshiba TEC B-SX4T Series Maintenance Manual page 105

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
24) Fix the harness ass'y with the clamp.
25) Connect the 9-pin connector of the harness ass'y to CN15, and 2-pin connector to CN18 on the
Main PC board, respectively.
26) Connect the four harnesses of the cutter unit to CN8, CN10, CN11 and CN12 on the cutter drive
unit.
Cutter Unit
Mantenimiento Periféricos Informáticos C/Canteras,15 28860 Paracuellos de Jarama Madrid Tel: 91 748 16 04 www.mpi.com.es
CN15 (9 pins) CN18 (2 pins)
Main PC Board
Harness Ass'y
Cutter Drive Unit
CN8 CN12
4-88
EO18-33012B
4.13 ROTARY CUTTER (B-8204-QM-R)
Clamp
CN10
CN11