How To Enter The System Mode; Parameter Setting - Toshiba B-SA4TP SERIES Owner's Manual

2. PRINTER SETUP
2.7.1 How to Enter the
System Mode
ONLINE
B-SA4T V1.0
PAUSE
B-SA4T V1.0
R

2.7.2 Parameter Setting

<2>PARAMETER SET
This section describes how to enter the System Mode.
1. Turn on the printer and confirm that "ONLINE" appears on the LCD
Message Display.
2. Press the [PAUSE] key to pause the printer.
P
3. Hold down the [RESTART] key for three seconds until "<1>RESET"
is displayed.
4. Press the [FEED] key, and "<2>PARAMETER SET" appears on the
LCD Message Display.
If the [PAUSE] key is pressed with "<1>RESET" being displayed, the
printer will turn to an idle state and the message will change to "ONLINE".
In this section, how to select a language and how to set the
communication parameters are described. When further information is
required, refer to the B-SA4T Series Key Operation Specification.
While "<2>PARAMETER SET" is displayed on the LCD Message
Display, press the [PAUSE] key to enter the Parameter Setting Mode.
P
NOTE:
E2-17
ENGLISH VERSION EO1-33048
2.7 Setting an Operating Environment