Table of Contents
Advertisement
TCP/IP Panel
The TCP/IP panel connects PCS to a specific device through Ethernet. To access this
panel, click the TCP/IP tab to the left of the Device Discovery panel (see figure 37,
Figure 37.
To connect directly to a connected device with a known IP address:
In the IP Address/Hostname field of the Target Device panel (
1.
address of the desired device.
2.
If required, enter the device password in the Password field.
NOTES:
•
•
3.
In the Port field (
4.
Click the Connect button (
To connect indirectly to a device through a control processor via an AV LAN:
If your DTP2 CrossPoint 82 is connected to an AV LAN, you can connect to it through a
control processor such as an Extron IPCP, as follows:
1.
In the IP Address/Hostname field of the
address of the DTP2 CrossPoint 82 on the AV LAN, as well as the port number and the
password (if needed).
2.
Select the Enable Indirect Connection checkbox (
3.
In the IP Address/Hostname field of the IP Link Control Processor with AV LAN
panel (
DTP2 CrossPoint 82 Scaling Presentation Matrix Switchers • Configuration Software
TCP/IP Panel
The factory configured passwords for all accounts on this device have been set
to the device serial number. Passwords are case sensitive.
If desired, select the Show Characters checkbox (below the Port field) to
display the password characters.
), enter the port number of the desired device (the default is 23).
4
). A new device tab opens.
5
), enter the IP address of the control processor connected to the AV LAN.
4
), enter the IP
2
Device panel (
), enter the IP
Target
2
).
3
).
1
97
Advertisement
Table of Contents
