To insert IR signals via the Over TP captive screw connector:
1.
Connect the COM (serial) port of the control system to the Over TP IR captive screw
port (output port 2 in this example).
2.
Connect the TP cable from the DTP2 CrossPoint 82 RJ-45 Out connector to the DTP
input of the endpoint.
3.
Connect the endpoint to the device to be controlled.
4.
Wire an IR emitter to the IR connector of the twisted pair receiver, and place the emitter
on the display device.
DTP2 CrossPoint 82 Scaling Presentation Matrix Switchers • Operation
52