Table of Contents
Advertisement
•
INn: Auto Memory — Enables or disables Auto Memory. When Auto Memory is set to
On (default), the DTP2 CrossPoint 82 stores the current input configuration and picture
control values.
The switcher stores 32 auto memories per input, with input configuration and picture
control data for each video resolution. The default setting enables these memories to
automatically recall input and picture controls for previously applied signals. When auto
memories are disabled, the switcher treats every applied signal as a new source.
Input Switch Effect — Enables you to select the transition effect that is shown on the
•
display while the switcher is switching inputs (see the examples in figure 28). Press the
or
button to select from the following available effects:
1 1 1 1
Seamless Cut
4 4 4 4
Cut Through Black
Figure 28.
Transition Effects
The switch effects, listed below in order of appearance on the menu, include:
•
Seamless Fade (default) — Displays a final frozen frame of the previous input while
the newly selected input fades in (see figure 28,
•
Fade thru Black — The current input fades to black before the newly selected
input fades in (
).
3
•
Cut thru Black — The current input instantly cuts to black, then immediately cuts
to the newly selected input with no fading in or out (
Seamless Cut — The last frame of video freezes on the screen, then cuts to the
•
newly selected input (
•
Factory Reset — Resets the unit to its factory default values (removing any
user-specified values) while retaining all network settings.
To reset using the OSD menu, press and hold the
displayed (approximately 5 seconds). The message remains for approximately 1 minute
after the reset is complete to allow time for the display device to sync with the DTP2
CrossPoint 82 output.
NOTE: The equivalent SIS command is E ZXXX } . This command does not affect
the current password, including the initial factory-set serial number.
For other reset methods, see
DTP2 CrossPoint 82 Scaling Presentation Matrix Switchers • Operation
2 2 2
Seamless Fade
3 3 3
Fade Through Black
2
).
1
Enter
Reset Modes
starting on page 47.
).
).
4
button until Factory Reset is
44
Advertisement
Table of Contents
